Hyundai Sonata: A/C Pressure Transducer Repair procedures - Air Conditioning System - Heating, Ventilation and Air ConditioningHyundai Sonata: A/C Pressure Transducer Repair procedures

Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminal "1" and "2".

2.
Inspect the voltage value whether it is sufficient to be regular value or not.


Vdd * (0.001758 * Pressure(Psia) + 0.074126

3.
If the measured voltage value is not wihtin specification, replace the A/C pressure transducer.
Diagnosis With GDS
1.
The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
? The diagnostic system (GDS) provides the following information.
(1) Self diagnosis: Checking the failure code (DTC) and display.
(2) Current data: Checking the system input/output data state.
(3) Actuation test: Checking the system operation condition.
(4) Additional function: Other controlling such as he system option and zero point adjustment.
2.
Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.
3.
Select the 'Current data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the A/C Pressure Transducer can be checked.

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/charging station.
3.
Disconnect the A/C pressure transducer connector (A).

4.
Remove the A/C pressure transducer (A).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

   
Be careful not to bend the liquid & suction pipe.
5.
Install in the reverse order of removal.
   
When installing, replace it with a new O-ring (A).

    A/C Pressure Transducer Description and Operation
    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the coolin ...

    Evaporator Temperature Sensor Description and Operation
    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. ...

    See also:

    Description and Operation
    Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows beh ...

    Water Temperature Control Assembly Repair procedures
    Removal and Installation 1. Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed. 2. Disconnect the battery negative terminal. 3. Remove the air ...

    Restrictions in handling keys
    When leaving keys with parking lot and valet attendants, the following procedures will ensure that your vehicle’s trunk and glove box compartment can only be opened with the master key. Lock W ...