Hyundai Sonata: Air intake control - Manual heating and air conditioning - Automatic climate control system - Features of your vehicleHyundai Sonata: Air intake control

Type A

Type A

Type B

Type B

Adjusting the driver and passenger side temperature individually

1. Press the DUAL button to operate the driver and passenger side temperature individually. Turning the right temperature control knob will automatically switch to the DUAL mode as well.

2. Turn the left temperature control knob to adjust the driver side temperature. Turn the right temperature control knob to adjust the passenger side temperature.

When the driver side temperature is set to the highest or lowest temperature setting, the DUAL mode is deactivated for maximum heating or cooling.

Adjusting the driver and passenger side temperature equally

1. Press the DUAL button again to deactivate DUAL mode. The passenger side temperature will be set to the same temperature as the driver side temperature.

2. Turn the left temperature control knob. The driver and passenger side temperature will be adjusted equally.

    Temperature control
    Type A Type B The temperature will increase to the maximum by turning the knob to the right. The temperature will decrease to the minimum by turning the knob to the left. When turning the ...

    Air intake control
    Type A Type B This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air po ...

    See also:

    Heating and air conditioning
    1. Start the engine. 2. Set the mode to the desired position. To improve the effectiveness of heating and cooling : - Heating: - Cooling: 3. Set the temperature control to the desired position. ...

    Anchor Pretensioner (APT). Repair procedures
    Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Using a flat-trip screwd ...

    Power Door Lock Switch. Repair procedures
    Inspection Driver Door Lock Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. ...