Hyundai Sonata: Automatic heating and air conditioning - Automatic climate control system - Features of your vehicleHyundai Sonata: Automatic heating and air conditioning

1. Press the AUTO button. The modes, fan speeds, air intake and air-conditioning

1. Press the AUTO button. The modes, fan speeds, air intake and air-conditioning will be controlled automatically according to the temperature setting.

Type A

Type A

Type B

Type B

2. Turn the temperature control knob to set the desired temperature.

✽ NOTICE

  • To turn the automatic operation off, select any button of the following:
    - Mode selection button
    - Front windshield defrost button
    - Fan speed control button
    The selected function will be controlled manually while other functions operate automatically.
  • For your convenience and to improve the effectiveness of the climate control, use the AUTO button and set the temperature to 73°F (23°C).

✽ NOTICE

✽ NOTICE

Never place anything over the sensor located on the instrument panel to ensure better control of the heating and cooling system.

    Automatic climate control system
    Type A Type B 1. Front windshield defrost button 2. Rear window defrost button 3. AUTO (automatic control) button 4. OFF button 5. Driver’s temperature control knob 6. Mode indicator 7. ...

    Manual heating and air conditioning
    The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of b ...

    See also:

    Auto Head Lamp Leveling Unit Troubleshooting
    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. NoProcedure1Locate vehicle to flat plane2Tire check3IG ...

    Seat Belt Pretensioner (BPT). Repair procedures
    Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Using a flat-tip screwdr ...

    Knock Sensor (KS) Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect ...