Hyundai Sonata: Canister Close Valve (CCV) Repair procedures - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Canister Close Valve (CCV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV terminal 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.
Disconnect the vapor hose connected with the canister from the CCV.
6.
Connect a vacuum pump to the nipple.
7.
Ground the CCV control line and apply battery voltage to the CCV power supply line.
8.
Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Remove the rear-left wheel & tire and the wheel house cover.
4.
Disconnect the canister close valve connector (A).
5.
Disconnect the ventilation hose (B) connected to the fuel tank air filter and canister close valve.
6.
Remove the fuel tank air filter after removing the installation bolt (C).

7.
Release the lever (A), and then rotate the canister close valve (B) in the direction of an arrow.
8.
Remove the canister close valve from the fuel tank air filter.

Installation
   
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
    See also:

    TPMS (Tire Pressure Monitoring System) malfunction indicator
    The TPMS malfunction indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System. If the system is able to correctly d ...

    Troubleshooting
    Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine strugg ...

    Front fog light
    Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow etc. The fog lights will turn on when fog light switch (1) is turned to ON after the headlig ...