Hyundai Sonata: Crash Pad Garnish Assembly [RH] Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Sonata: Crash Pad Garnish Assembly [RH] Repair procedures

Replacement
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

2.
After loosen the mounting screws, remove the crash pad passenger side garnish (A).

3.
After loosening the mounting screw, then remove the crash pad garnish assembly [RH] (A).

4.
Install in the reverse order of removal.
   
Replace any damage clips.
    Crash Pad Garnish Assembly [RH] Components and Components Location
    Component Location 1. Crash pad garnish assembly [RH] ...

    Crash Pad Lower Panel Components and Components Location
    Component Location 1. Crash pad lower panel ...

    See also:

    Power window lock button
    The driver can disable the power window switches on a front and rear passenger door by pressing the power window lock button located on the driver’s door to the LOCK position (pressed). ...

    Steering Angle Sensor Repair procedures
    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be ...

    Front Door. Components and Components Location
    Components 1. Door module 2. Window glass 3. Outside handle 4. Outside handle cover 5. Door lock assembly 6.Door handle pad 7. Door panel 8. Door chec ...