Hyundai Sonata: Crash Pad Under Cover Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Sonata: Crash Pad Under Cover Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad under cover [RH] (A).

2.
Disconnect the under lamp connector (A).

3.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Crash Pad Side Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    Main Crash Pad Assembly Components and Components Location
    Component Location 1. Main crash pad assembly ...

    See also:

    Intake Air Temperature Sensor (IATS) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the speci ...

    Rear Bumper Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with ...

    Troubleshooting
    Troubleshooting     • The battery must be in good condition and fully charged for this troubleshooting. ...