Hyundai Sonata: Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - RestraintHyundai Sonata: Curtain Airbag (CAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim. (Refer to the Body group- Interior)
3.
Disconnect the curtain airbag harness connector.

4.
After loosening the mounting bolts and nuts remove the curtain airbag.


Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts and nuts.

Tightening torque:
Bolts : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Nuts : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

•
Never twist the airbag module during installation. If the airbag module is twisted, it may not operate as designed.
4.
Connect the curtain airbag connector.
5.
Install the roof trim. (Refer to the Body group- Interior)
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Airbag Module Disposal. Description and Operation
    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airb ...

    See also:

    Rear Repair procedures
    Replacement Rear Seat Belt Replacement • When installing the belt, make sure not to damaged the ...

    Repair procedures
    Inspection 1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. ...

    Checking the coolant level
    WARNING Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in se ...