Hyundai Sonata: CVVT Oil Control Valve (OCV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Sonata: CVVT Oil Control Valve (OCV). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the installation bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply engine oil to the valve O-ring.
1.
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Variable Intake Solenoid (VIS) Valve. Description and Operation
    Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ...

    See also:

    Crash Pad. Components and Components Location
    Components 1. Main crash pad 2. Air vent 3. Center air vent 4. Cluster lower panel 5. Cluster assembly 6. Cluster facia side panel 7. Key set bezel 8. ...

    Start/Stop Button. Repair procedures
    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad&q ...

    Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to the BD group - "Cra ...