Hyundai Sonata: DCT Control Module (TCM) Repair procedures - Dual Clutch Transmission Control System - DCT (Dual Clutch Transmission) SystemHyundai Sonata: DCT Control Module (TCM) Repair procedures

Inspection
Transmission Control Module (TCM) Inspection Procedure
1.
Inspecting TCM ground circuit: Measure the resistance between the TCM and chassis ground.
(Check the terminal connected to the chassis ground while using the back of the harness connector as the base point for TCM.)

Normal reading (resistance): Below 1?

2.
Inspecting the TCM connector: Disconnect the TCM connector and visually inspect to see whether there is a bend on the ground terminal of the harness connector. Also visually check the connection pressure.
3.
If no problem is found during inspection in step 1 and step 2, then the problem is with the TCM itself. In this case, replace the TCM and inspect the vehicle again.
4.
Re-inspecting TCM: Install the TCM that was determined to have malfunctioned from step 3 in another vehicle. Reset the error code and then check the operation in that vehicle. If the vehicle operates without any problems, then inspect the first vehicle with the initial problem again.
Removal
1.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the air duct (A).

3.
Disconnect the TCM connector (A).

4.
Remove the TCM (A) after removing the bracket mounting nut (B-3ea).

5.
Remove the TCM from the bracket after loosening the bolt (A-4ea).

Installation
1.
Install in the reverse order of removal.
   
Perform the clutch touch point learning procedure using the GDS after replacing TCM

    DCT Control Module (TCM) Schematic Diagrams
    1. TCM Connector and Terminal Function 2. TCM Terminal Function Connector [A] PinDescriptionPinDescription1Clutch Actuator (Clutch Motor 1 (ODD)_Phase V)17-2Clutch actuator (Clutch Motor 2 (EVEN) ...

    Clutch Actuator Assembly Components and Components Location
    Components 1. Clutch actuator assembly2. Fork cover ...

    See also:

    Crash Pad Side Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    Starter Schematic Diagrams
    Circuit Diagram ...

    EBD(Electronic Brake-force Distribution). Description and Operation
    Operation The EBD system (Electronic Brake force Distribution) as a sub-system of the ABS system is to control the maximum braking effectiveness by the rear wheels. It further utilizes ...