Hyundai Sonata: Delta Garnish Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Sonata: Delta Garnish Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the delta garnish (A).

2.
Install in the reverse order of removal.
   
Replace any damaged clips (or pin-type retainers).
    Roof Side Molding Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    Front Wheel Guard Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...

    See also:

    Blower Motor Repair procedures
    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...

    Electric power steering (EPS)
    The power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will requi ...

    Input shaft speed sensor 1 Repair procedures
    Removal 1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner") 2. Remove the TCM. (Refer to Dual Clutch Transmission Control System - "TCM") ...