Hyundai Sonata: Engine compartment fuse replacement - Fuses - MaintenanceHyundai Sonata: Engine compartment fuse replacement

1. Turn the ignition switch and all other switches off.

1. Turn the ignition switch and all other switches off.
2. Remove the fuse panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, use the fuse puller in the engine compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure it fits tightly in the clips. If it fits loosely, consult an authorized HYUNDAI dealer.

CAUTION

After checking the fuse panel in the engine compartment, securely install the fuse panel cover. If not, electrical failures may occur from water contact.

Multi fuse

Multi fuse

If the multi fuse is blown, it must be removed as follows:

1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right side in the engine compartment.
4. Remove the nuts shown in the picture above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.

✽ NOTICE

If the multi fuse is blown, consult an authorized HYUNDAI dealer.

    Instrument panel fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Open the fuse panel cover. 3. Pull the suspected fuse straight out. Use the removal tool provided in the engine compartment fuse ...

    Fuse/relay panel description
    Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. Inner panel fuse panel Engine compartment fuse panel ✽ NOTICE Not al ...

    See also:

    Console. Components and Components Location
    Components 1. Console assembly 2. Console upper cover 3. Extension side cover 4. Crash pad garnish ...

    Windshield Wiper-Washer Switch. Repair procedures
    Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Wiper Switch Washer S ...

    Heated Oxygen Sensor (HO2S). Specifications
    Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.5 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2 ...