Hyundai Sonata: Front Bumper Cover Repair procedures - Front Bumper - Body (Interior and Exterior)Hyundai Sonata: Front Bumper Cover Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Loosen the front bumper upper mounting clips.

2.
Loosen the front bumper lower mounting clips.

3.
After loosening the front bumper (A) side's mounting clips and screw, then disconnect the side's.
   
Remove the front bumper by pulling up the side of the front bumper and then pull it out.
   
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.
Disconnect the front bumper main connector (A).

5.
Remove the front bumper cover (A).

6.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Front Bumper Cover Components and Components Location
    Component Location 1. Front bumper cover ...

    Radiator Grill Components and Components Location
    Component Location 1. Radiator grill ...

    See also:

    Rear Body. Body Repair
    ...

    Water pump Repair procedures
    Removal 1. Loosen the drain plug (A), and drain the engine coolant. Remove the radiator cap to drain with speed.     System is under high pressure when the engine is hot.To avoi ...

    Output Speed Sensor. Specifications
    Specification Item Specification Type Hall Effect Sensor,  2pins (Power: 9V, Signal) Operation condition -40 ...