Hyundai Sonata: Front Door Latch Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Sonata: Front Door Latch Repair procedures

Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
To remove the front door outside handle base connector (A), widen both sides of the lock pins in the direction of the arrow and then push back the front door outside handle base connector.

3.
Remove the connector (A) by pressing the locking pin and seperate the wiring harness (B) on the upper of front door latch.

4.
Remove the front door inside handle cage (A).

5.
Remove the front door latch assembly (A) by pulling it in the direction of the arrow.

6.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

7.
Remove the front door outside handle cable (A).

8.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Make sure the door locks / unlocks and opens / closes properly.
Replace any damaged clips.
    Front Door Side Weatherstrip Repair procedures
    Replacement 1. Loosen the front door checker (B) mounting bolt. 2. Detach the clips, then remove the front door side weatherstrip (A). Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m ...

    Rear Door
    ...

    See also:

    Troubleshooting
    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

    Side Impact Sensor (SIS). Description and Operation
    Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

    Opening the hood
    WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position for automatic transaxle and to the 1st(First) gear or R(Reverse) for man ...