Hyundai Sonata: Front Fog Lamps. Repair procedures - Lighting System - Body Electrical SystemHyundai Sonata: Front Fog Lamps. Repair procedures

Inspection

1.
Disconnect the negative(-) battery terminal.
2.
Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch)
3.
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.

Front Fog Lamp

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
3.
Disconnect the front fog lamp connector (A).
4.
Replace the front fog bulb (A) turning it in the counter clock-wise direction.

Installation

1.
Install the front fog bulb.
2.
Reconnect the lamp connector.
3.
Install the front bumper.

    Rheostat. Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lower crash pad switch (A) from the side crash pad cover by usin ...

    High Mounted stop lamp. Repair procedures
    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the rear seat. (Refer to the BD group - "Rear seat") ...

    See also:

    ETC (Electronic Throttle Control) System. Specifications
    Specification [Throttle Position Sensor (TPS)] Throttle Angle(°) Output Voltage(V) TPS1 TPS2 0 0.0 5.0 ...

    Illuminated engine start/stop button
    Whenever the front door is opened, the engine start/stop button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. ...

    Description and Operation
    Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed ...