Hyundai Sonata: Fuel Pressure Sensor (FPS) Description and Operation - Fuel Delivery System - Engine Control / Fuel SystemHyundai Sonata: Fuel Pressure Sensor (FPS) Description and Operation

Description
The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.
Based on the fuel pressure measured by the FPS and the amount of fuel consumed, the fuel pump control module (FPCM) determines whether to activate the low pressure fuel pump.
After activating the low pressure fuel pump, the FPS continues to provide the fuel pressure information to the FPCM and the FPCM keeps controlling the fuel flow rate using the feedback information from the FPS.

    Fuel Pump Control Module (FPCM) Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. emove the rear seat cushion. ( Refer to Body - "Rear Seat Assembly") 3. Remove the fuel pump ser ...

    Fuel Pressure Sensor (FPS) Specifications
    Specification Pressure [KPa (kgf/cm?, psi)]Output Voltage (V)50 (0.51, 7.3)0.3600 (6.12, 87.0)2.51100 (11.2, 159.5)4.5 ...

    See also:

    Repair procedures
    General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and ...

    Audio Unit Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia upper panal. (Refer to Body - "Cluster Fascia Upper Panel") 3. Remove the audio head unit (A) after l ...

    Overhead Console Lamp. Schematic Diagrams
    Circuit Diagram ...