Hyundai Sonata: Glove Box Upper Cover Assembly Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Sonata: Glove Box Upper Cover Assembly Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Disconnect the stopper (B) from the glove box (A).

2.
Disconnect the air damper (A) from the glove box (B).

3.
Disconnect the pins (A) and then remove the glove box (B).

4.
Using a screwdriver or remover, remove the front door scuff tirm [RH] (A).

5.
Using a screwdriver or remover, remove the cowl side tirm [RH] (A).

6.
Using a screwdriver or remover, remove the crash pad under cover [RH] (A).

7.
Disconnect the under lamp connector (A).

8.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

9.
After loosen the mounting screws, remove the crash pad passenger side garnish (A).

10.
After loosen the mounting screws, remove the crash pad side garnish assembly [RH] (A).

11.
After loosening the mounting screws, then remove the glove box upper cover assembly (A) by using a screw driver.

12.
Disconnect the glove box lamp connector (A).

13.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Replace any damage clips.
    Steering Column Shroud Panel Components and Components Location
    Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

    See also:

    Engine Mounting. Components and Components Location
    Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Sub frame 4. Engine mounting bracket 5. Engine mounting support bracket ...

    Cruise Control Switch. Repair procedures
    Removal and Installation 1. Disconnect the battery negative terminal. Tightening torque : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft) ...

    Stop Lamp Switch Repair procedures
    Adjustment 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the lower crash pad. (Refer to Body - "Crash Pad") 3. Remove the knee airbag. (Refer to Rs ...