Hyundai Sonata: Heater & A/C Control Unit (Manual) Repair procedures - Controller - Heating, Ventilation and Air ConditioningHyundai Sonata: Heater & A/C Control Unit (Manual) Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the A/C & heater controller connectors (A).

4.
Remove the heater and A/C controller (A) from the center facia panel.

5.
Install in the reverse order of removal.
   
Make sure the connector are connected in properly.
Replace any damaged clips.
    Heater & A/C Control Unit (Manual) Components and Components Location
    Components Connector [A] Pin NOFunctionPin NOFunction1ILL+ (TAIL)21Detent OUT (+)2Sensor REF (+5V)22HTD3Mode control actuator (Vent)23Rear defog switch4Mode control actuator (Defrost)24C_CAN High5 ...

    Heater & A/C Control Unit (DATC) Components and Components Location
    Components Connector [A] Pin NOFunctionPin NOFunction1ILL+ (TAIL)21Detent OUT (+)2Sensor REF (+5V)22HTD (Rear defog indicator)3Mode control actuator (Vent)23Rear defog switch4Mode control actuator ...

    See also:

    Troubleshooting
    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. ...

    Cylinder Head Repair procedures
    Removal Engine removal is not required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait u ...

    Basic Service Symbols
    General Information There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. SymbolMeaningDo not reuse the par ...