- Integrated one unit for input & output speed sensor

- Differential current type (low: 7mA, high: 14mA)

- Failsafe: 4th gear hold (D), 2nd ~ 4th manual shift (S)

Transaxle Control Module (TCM). Repair procedures

Replacement In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching&quo ...

Input Speed Sensor. Specifications

Specification Item Specification Type Hall Effect Sensor,  2pins (Power: 9V, Signal) Operation condition -40 ~15 ...

See also:

Rear Hub - Carrier. Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Repair procedures
Inspection [System Inspection] 1. Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body. 2 ...