Hyundai Sonata: Knock Sensor (KS) Description and Operation - Engine Control System - Engine Control / Fuel SystemHyundai Sonata: Knock Sensor (KS) Description and Operation

Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking.
When knocking occurs, the vibration from the cylinder block is applied as pressure to the piezoelectric element. When a knock occurs, the sensor produces voltage signal. The ECM retards the ignition timing when knocking occurs. If the knocking disappears after retarding the ignition timing, the ECM will advance the ignition timing. This sequential control can improve engine power, torque and fuel economy.

    Camshaft Position Sensor (CMPS) Repair procedures
    Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON’T remove the camshaft pos ...

    Knock Sensor (KS) Specifications
    Specification ItemSpecificationResistance(M?)4.87 ...

    See also:

    Advanced Smart Cruise Control (ASCC) Switch Components and Components Location
    Components 1. SET - switch2. RES + switch3. ASCC switch4. CANCEL switch5. CRUISE switch ...

    Front Door Outside Handle Repair procedures
    Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the front door lock (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) ...

    Repair procedures
    Adjustment Glass Adjustment     • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. (Refer to Re ...