Hyundai Sonata: Panorama sunroof - Features of your vehicleHyundai Sonata: Panorama sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.

The sunroof can only be opened, closed, or tilted when the ignition switch is in the ON position.

✽ NOTICE

  • In cold and wet climates, the sunroof may not work properly due to freezing conditions.
  • After washing the car or after there is rain, be sure to wipe off any water that is on the sunroof before operating it.

CAUTION

  • Do not continue to move the sunroof control lever after the sunroof is fully opened, closed, or tilted. Damage to the motor or system components could occur.
  • Make sure the sunroof is fully closed when leaving your vehicle. If the sunroof is opened, rain or snow may leak through the sunroof and wet the interior as well as cause theft.

✽ NOTICE

The sunroof cannot slide when it is in the tilt position nor can it be tilted while in an open or slide position.

WARNING

  • Never adjust the sunroof or sunshade while driving. This could result in loss of control and an accident that may cause death, serious injury, or property damage.
  • Do not allow children to operate the sunroof.
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is blown, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position and close the sun ...

Sunshade
To open the sunshade, pull the sunroof control lever backward to the first detent position. To close the sunshade when the sunroof glass is closed, push the sunroof control lever forwar ...

See also:

Phone
Before using the Bluetooth® Wireless Technology enabled phone features In order to use Bluetooth® Wireless Technology phone, you must first pair and connect the Bluetooth® Wireless Technolog ...

Canister Close Valve (CCV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the ...

Muffler. Repair procedures
Removal and Installation 1. Remove the front muffler (B) after disconnecting the oxygen sensor connector (A) (ULEV only). Tightening torque: ...