When replacing parts, use HYUNDAI genuine parts.
Replacement
Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
If removed, the following parts should always be replaced with new ones.
| 5. |
Cotter pins (split pins)
|
| 6. |
Plastic nuts
Depending on their location.
|
| 7. |
Sealant should be applied to gaskets.
|
| 8. |
Oil should be applied to the moving components of parts.
|
| 9. |
Specified oil or grease should be applied to the prescribed locations (oil seals, etc) before assembly.
|
Adjustment
Use gauges and testers to adjust correctly the parts to standard values correctly.
Be sure that all necessary tools and measuring equipment
are available starting work.
Special Tools
Use special tools when they are required.
Removal Of Parts
First find th ...
1.
Be sure to disconnect the battery cable from the
negative (-) terminal of the battery.
2.
Never pull on the wires when disconnecting c ...
See also:
Automatic Transaxle. Repair procedures
Removal
1.
Remove the following items;
A.
Air duct (A) and engine cover (B). (Refer
to "Intake and Exhaust system" in EM group. ...
Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open.
Place your sunglasses in the compartment door with the lenses facing out. Push to
close.
WARNING
Do not keep ...
Schematic Diagrams
Circuit Diagram
...
Hyundai Sonata: Parts
Preparation Of Tools And Measuring Equipment
Electrical System