Hyundai Sonata: Rear Door Module Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Sonata: Rear Door Module Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Loosen the rear door outside handle base mounting bolt (A).

4.
After loosening the mounting bolt and nuts, then remove the rear door channel (A).

Tightening torque :
Bolt: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Nut: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

5.
Loosen the rear door latch (A) mounting screws.
6.
After loosening the mounting bolts, then remove the rear door module (B).

Tightening torque :
Bolt: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Screw: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

7.
Disconnect the connectors and front door module wiring harness (A).

8.
Remove the rear door latch assembly.
(Refer to Front Door - "Rear Door Latch")
9.
Reomove the rear speaker .
(Refer to Body Electrical System - "Speakers")
10.
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor")
11.
Install in the reverse order of removal.
   
The area of whole parts should be applied with sufficient grease.
Make sure connectors are connected properly and each rod is connected securely.
Make sure the door locks / unlocks and opens / closes properly
    Rear Door Module Components and Components Location
    Component Location 1. Rear door module ...

    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    See also:

    Resetting the sunroof
    Whenever the vehicle battery is disconnected or discharged, or related fuse is open, you must reset your sunroof system as follows: 1.Turn the ignition switch to the ON position and close the sunro ...

    Checking the engine oil level
    2.4 engine 2.0 engine 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes ( ...

    Auto Light Sensor. Repair procedures
    Inspection In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto lig ...