Hyundai Sonata: Rear Oil Seal Repair procedures - Cylinder Block - Engine Mechanical SystemHyundai Sonata: Rear Oil Seal Repair procedures

Removal
1.
Remove the transaxle assembly.
(Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")
2.
MT : Remove the flywheel.
(Refet to Cylinder Block - "Flywheel")
3.
AT : Remove the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Remove the rear oil seal (A).

Installation
1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST (09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.
MT : Install the flywheel.
(Refet to Cylinder Block - "FlyWheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to transaxle - "Manual Transaxle assembly, Auto Transaxle assembly")
    Rear Oil Seal Components and Components Location
    Components 1. Rear oil seal ...

    Cylinder Block Components and Components Location
    Components 1.  Cylinder block2.  Ladder frame3.  Crank shaft4.  Crank shaft upper bearing5.  Crank shaft lower bearing6.  Thrust bearing7.  Main bearing cap8.&n ...

    See also:

    Description and Operation
    Description The Evaporative Emission Control System prevents fuel vapor stored in fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel tank, the vapor passes t ...

    Description and Operation
    Description Body Control Module (BCM) Function NoItemDescription1Washer Linked Wiper - If the washer switch is pressed ON for 0.06~0.2 second with the vehicle mode in IGN2, the wiper rela ...

    Shift Lever. Repair procedures
    Removal 1. Remove the front console assembly.(Refer to "Interior" in BD group) 2. Remove the snap pin (A) and the clips (B). ...