Hyundai Sonata: Rear Seat Belt Retractor Repair procedures - Rear Seat Belt - Body (Interior and Exterior)Hyundai Sonata: Rear Seat Belt Retractor Repair procedures

Replacement
   
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray Trim")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

3.
After loosening the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[LH]

[RH]

4.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Rear Seat Belt Retractor Components and Components Location
    Component Location 1. Rear seat belt retractor [LH]2. Rear seat belt retractor [RH] ...

    Rear Center Seat Belt Retractor Components and Components Location
    Component Location 1. Rear center seat belt retractor ...

    See also:

    Rear Disc Brake Repair procedures
    Removal [General Type] 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A).     Be careful not to damage to the wheel cap(A) when remo ...

    Power Seat Control Switch. Schematic Diagrams
    Circuit Diagram ...

    Winter driving
    More severe weather conditions of winter result in greater wear and other problems. To minimize winter driving problem, you should follow these suggestions: Snowy or icy conditions To drive yo ...