Hyundai Sonata: Rear Seat. Repair procedures - Seat & Power Seat - Body (Interior and Exterior)Hyundai Sonata: Rear Seat. Repair procedures

Replacement

Seat Assembly Replacement
1.
After loosening the mounting bolts, then remove the rear seat assembly (A).
Tightening torque :
44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.5 ~ 43.4 lb-ft)

2.
Disconnect the seat heater connectors (A).
3.
Installation is the reverse of removal.
Seat mounting bolt and nut installation procedure.
•
Tighten temporarily in the order of nut and bolt on the front of recliner hinge installation part.
•
After completely tightening completely the bolt on the back of the recliner hinge installaion part, tighten the bolt on the front of it completely.
•
Setting down the seat cushion, tighten the mounting bolt of the cushion frame hinge.
•
Check if reclining the seat and folding seat back operate smoothly.
Armrest Replacement
1.
After loosening the mounting nuts, then remove the armrest(A).
2.
Installation is the reverse of removal.

    Rear Seat. Components and Components Location
    Components 1. Rear seat back 2. Rear seat cushion 3. Armrest ...

    Seat Belt
    ...

    See also:

    Smart key functions
    Carrying the smart key, you may lock and unlock the vehicle doors. Also, you may start the engine. Refer to the following, for more details. Locking Using the door handle switch Pressing ...

    Balance Shaft & Oil Pump. Repair procedures
    Removal 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance ...

    Rear Cross Member. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...