Hyundai Sonata: Repair procedures - Evaporative Emission Control System - Emission Control SystemHyundai Sonata: Repair procedures

Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
Engine
Operating
Condition
Applied
Vacuum
Result
Idle
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum is held
3,000rpm

2.
Check the following points with applied vacuum at the purge control solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
Engine
Operating
Condition
Applied
Vacuum
Result
Idle
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum is held
Within 3 minutes after engine start at 3,000 rpm
Try to apply vacuum
Vacuum is released
In 3 minutes after engine start at 3,000 rpm
Min. 20 inHg
(Min. 0.7 kgf/cm?, Min. 67.7 kPa)
Vacuum will be held momentarily, after which, it will be released

[PCSV Inspection]
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the PCSV connector (A).
3.
Disconnect the vapor hose (B) which is connected to the intake manifold from the PCSV.

4.
After connecting a vacuum pump to the nipple, apply vacuum.
5.
With the PCSV control line grounded, check the valve operation with battery voltage applied to the PCSV(Open) and removed(Closed).
Battery Voltage
Valve
Vacuum
Connected
Open
Released
Disconnected
Close
Maintained

6.
Measure the coil resistance of the PCSV.

Specifications:
22.0 ~ 26.0? [20°C(68°F)]

[EVAP. Leakage Test]
1.
Select "Evap. Leakage Test".

2.
Proceed with the test according to the screen introductions.

    Schematic Diagrams
    Schematic Diagram Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake manifold by t ...

    Canister Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect th ...

    See also:

    Crankshaft Damper Pulley Repair procedures
    Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the engineroom under cover. 3. Remove the passenger side front tire. 4. Remove th ...

    Components and Components Location
    Components 1. Driver Airbag (DAB)2. Passenger Airbag (PAB)3. Knee Airbag (KAB)4. Curtain Airbag (CAB)5. Side Airbag (SAB) Components Location Supplemental Restraint System Control Module (SR ...

    Electric Parking Brake (EPB) Components and Components Location
    Components 1. VDC control module2. EPB switch3. Brake caliper4. EPB warning lamp5. AUTO HOLD lamp ...