Hyundai Sonata: Repair procedures - Fender - Body (Interior and Exterior)Hyundai Sonata: Repair procedures

Replacement
   
Be careful not to damage the fender and body.
   
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the head lamps.
(Refer to Body Electrical System - "Head Lamps")
3.
Remove the side sill moulding.
(Refer to Body Side Moulding - "Side Sill Moulding")
4.
Remove the front wheel guard.
(Refer to Body Side Moulding - "Front Wheel Guard")
5.
Remove the delta garnish.
(Refer to Body Side Moulding - "Delta Garnish")
6.
Remove the front bumper side mounthing bracket (A) after loosening the screw and bolt.

7.
Remove the fender assembly (A) after loosening the nut and bolts.

8.
Install in the reverse order of removal.
   
Replace any damaged clips.
    Components and Components Location
    Component Location 1. Fender assembly ...

    Hood
    ...

    See also:

    Starter Relay Repair procedures
    Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuse box cover. 3. Remove the starter relay (A). 4. Using an ohmmeter, check that th ...

    Rear Wheel Speed Sensor Repair procedures
    Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A).     Be careful not to damage to the wheel cap(A) when removing the it. ...

    Shift Lever. Components and Components Location
    Components 1. Shift lever assembly 2. Gear shift cable assembly 3. Clips 4. Retainer ...