Hyundai Sonata: Repair procedures - Trunk Trim - Body (Interior and Exterior)Hyundai Sonata: Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear package tray trim.
(Refer to Interior Trim - "Package Tray Trim")
4.
Remove the luggage cover board (A).
5.
Remove the rear transverse trim (B).
6.
Remove the luggage partition side trim (C).
7.
After loosening the mounting screws, then remove the luggage side trim (D).
8.
Install in the reverse order of removal.
   
Replace any damage clips.

1. Luggage side trim [LH]
2. Luggage side trim [RH]
3. TMK tray
4. Luggage cover board
5. Rear transverse trim
6. Package tray trim
7. Luggage partition side trim

    See also:

    Smooth cornering
    Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be ...

    To turn cruise control off, do one of the following
    Push the cruise ON/OFF button (the CRUISE indicator light in the instrument cluster will go off). Turn the ignition off. Both of these actions cancel cruise control operation. If you wa ...

    General Safety Information and Caution
    Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, ...