Hyundai Sonata: Repair procedures - Ignition Switch Assembly - Body Electrical SystemHyundai Sonata: Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Remove the steering column upper & Lower shroud.
4.
Remove the ignition switch (A) and disconnecting the Key Warning / immobilizer connector.

5.
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.

6.
Installation is the reverse of removal procedure.
Inspection
1.
Disconnect the ignition switch connector (A) and key warning switch connector (B) from under the steering column.

2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.

    See also:

    To increase cruise control set speed
    Follow either of these procedures: Push the RES+ switch and hold it. Your vehicle will accelerate. Release the switch at the speed you want. Push the RES+ switch and release it immediatel ...

    Water Pipe Repair procedures
    Removal and Installation 1. Remove the water temperature control assembly. (Refer to Colling System - "Water Temperature Control Assembly") 2. Remove the water pipe (A). Tightening torque ...

    Power windows
    The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window. The driver has a power window lock switch whic ...