Hyundai Sonata: Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs.
|
When the front airbag(s) deployed after a collision, replace the following
items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Anchor pretensioner(s)
|
| - |
Front impact sensors
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the
following items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the deployed side(s)
|
| - |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp fo ...
Components and Components Location
Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
4. Seat Belt Pretensioner (BPT)
5. Pressure Side Impact Sensor (P-SIS)
6. Side Impact Sensor (SIS ...
See also:
Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared
for the slick pavement. Here are a few things to consider when driving in the rain:
A heavy rainfall will make ...
Fuel Tank Pressure Sensor (FTPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specifica ...
Engine number
2.4 engine
2.0 engine
The engine number is stamped on the engine block as shown in the drawing. ...
