Hyundai Sonata: Specifications - General Information - Engine Electrical SystemHyundai Sonata: Specifications

Specifications

Ignition System
Items
Specifications
Ignition coil
Primary resistance
0.62 ± 10 % (Ω)
Secondary resistance
7.0 ± 15 % (kΩ)
Spark plugs
Type
FXU16HR11
Gap
1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)

Starting System
Items
Specifications
REMY
VALEO
Starter
Rated voltage
12V, 1.2kW
No. of pinion teeth
11
No-load characteristics
Voltage
11.5V
11V
Ampere
105A, MAX
70A, MAX
Speed
2,950rpm, MIN
2,400rpm, MIN

Charging System
Items
Specifications
Alternator
Type
Battery voltage sensing
Rate voltage
13.5 V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC regulator built-in type
Regulator setting voltage
External mode
ECU control
Internal mode
14.1 ± 0.3V
Temperature compensation
External mode
ECU control
Internal mode
-3.5 ± 2mV / °C
Battery
Type
54-26GL
Cold cranking amperage [at -18°C(-0.4°F)]
600A
Reserve capacity
110min
Specific gravity [at 25°C(77°F)]
1.280 ± 0.01

COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal voltage of 7.2V or greater at a specified temperature.
RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal voltage of 10.5V at 26.7°C(80.1°F).


    Troubleshooting
    Trouble Shooting Ignition System Symptom Suspect area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switc ...

    See also:

    Power Door Mirror Actuator. Repair procedures
    Inspection 1. Remove the front door quadrant delta cover. (Refer to the BD group - "Front door") 2. Disconnect the power door ...

    Navigation system
    The navigation system ascertains the present position of your vehicle by using information from satellites and guides you to the place you assign as the destination. Detailed information for the na ...

    Front Seat Outer Shield Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with pr ...