Hyundai Sonata: Starter Relay. Repair procedures - Starting System - Engine Electrical SystemHyundai Sonata: Starter Relay. Repair procedures

Inspection

1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
Terminal
 Continuity
30 - 87
 NO
85 - 86
 YES

4.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
5.
If there is no continuity, replace the starter relay.
6.
Install the starter relay.
7.
Install the fuse box cover.

    Starter. Repair procedures
    Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening tor ...

    See also:

    Crankshaft Position Sensor (CKPS). Schematic Diagrams
    Circuit Diagram ...

    Water pump. Components and Components Location
    Components 1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water pump housing 5. Water pump housing gasket 6. O-ring 7. Water inlet pipe 8. ...

    Fuel Filler Door Release Actuator. Repair procedures
    Inspection 1. Remove the trunk room left side trim. (Refer to the BD group - "Interior trim") 2. Open the fuel filler door an ...