Hyundai Sonata: Thermostat Repair procedures - Cooling System - Engine Mechanical SystemHyundai Sonata: Thermostat Repair procedures

Removal
   
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency.
1.
Drain engine coolant so that its level would be under the thermostat height.
2.
Remove the radiator lower hose.
(Refer to Cooling System - "Radiator Hose")
3.
Remove the water inlet fitting (A) and thermostat (B).

Inspection
1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.

Valve opening temperature:
82±1.5°C (179.6±2.7°F)
Full opening temperature: 95°C (203°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8mm(0.3in) or more at 95°C (203°F)

If the valve lift is not as specified, replace the thermostat.
Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

3.
Fill with engine coolant.
4.
Start engine and check for leaks.
    Thermostat Components and Components Location
    Components 1. Water inlet fitting2. Thermostat ...

    Thermostat Troubleshooting
    Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the thermostat gasket Check the mounting bolts • Check the torque of the mounting bolts • Retighten the bo ...

    See also:

    Cylinder Block Repair procedures
    Removal Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel") 2. ...

    Driver's and passenger's front air bag
    Driver’s front air bag Your vehicle is equipped with a Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating positions. The indications of th ...

    Panorama Sunroof Switch Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 screws holding the overhead console. Disconnect the sw ...