Hyundai Sonata: Trunk Lid Assembly Repair procedures - Trunk Lid - Body (Interior and Exterior)Hyundai Sonata: Trunk Lid Assembly Repair procedures

Replacement
   
Wear gloves to protect hands from injury.
   
When removing and installing the trunk lid, an assistant is necessary.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the connectors and trunk lid wiring harness (A).
3.
After loosening the mounting bolts, then remove the trunk lid assembly (B).

Tightening torque :
6.9 ~ 8.8 N.m (0.7 ~ 0.9 kgf.m, 5.1 ~ 6.5 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure the trunk lid locks / unlocks and opens / closes properly.
Adjust the trunk lid alignment.
Make sure the connectors are connected in properly.
Replace any damaged clips.
    Trunk Lid Assembly Components and Components Location
    Component Location 1. Trunk lid assembly ...

    Trunk Lid Trim Components and Components Location
    Component Location 1. Trunk lid trim ...

    See also:

    Components and Components Location
    Components 1. Receiver 2. TPMS sensor (FL) 3. TPMS sensor (RL) 4. TPMS sensor (RR) 5. TPMS sensor (FR) ...

    Antenna Components and Components Location
    Components ...

    Glove box
    The glove box can be locked and unlocked with a master key (or the mechanical key of the smartkey) (1). To open the glove box, pull the handle and the glove box will automatically open. Close ...