Hyundai Sonata: Canister. Repair procedures - Evaporative Emission Control System - Emission Control SystemHyundai Sonata: Canister. Repair procedures

Removal

1.
Disconnect the canister close valve connector (A).
2.
Disconnect the ventilation tube quick-connector (B) and the vapor tube quick-connectors (C, D).
3.
Remove the installation bolts (E), and then remove the canister.


Inspection

1.
Check for the following items visually.
- Cracks or leakage of the canister
- Loose connection, distortion, or damage of the vapor hose/tube

A: Canister ↔ Atmosphere
B: Canister ↔ Fuel Tank
C: Canister ↔ Intake Manifold

Installation

Installation is the reverse of removal.

Canister installation bolt:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)


    Repair procedures
    Inspection [System Inspection] 1. Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body. 2 ...

    Fuel Filler Cap. Description and Operation
    Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

    See also:

    Heating
    1. Set the mode to the position. 2. Set the air intake control to the outside (fresh) air position. 3. Set the temperature control to the desired position. 4. Set the fan speed control to the desi ...

    Starter. Repair procedures
    Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). Tightening tor ...

    Fuel Pressure Control Valve. Troubleshooting
    Signal Waveform ...