Hyundai Sonata: Fuel Filler Door Release Actuator. Repair procedures - Fuel Filler Door - Body Electrical SystemHyundai Sonata: Fuel Filler Door Release Actuator. Repair procedures

Inspection

1.
Remove the trunk room left side trim.
(Refer to the BD group - "Interior trim")
2.
Open the fuel filler door and remove the housing (A).
Do not reuse the fuel filler door housing.

3.
Remove the fuel filler door release actuator (A) after loosening the mounting bolts.

4.
Disconnect the release actuator connector (A).

5.
Check for continuity between terminal No.1 and No.2.
If there is no continuity, replace the fuel filler door opener.


    Components and Components Location
    Component Location 1. Fuel filler door open switch 2. Fuel filler door release actuator ...

    Fuel Filler Door Open Switch. Repair procedures
    Inspection 1. Remove the switch assembly (A) from the crash pad lower panel. 2. Disconnect the switch connector. 3 ...

    See also:

    Front Impact Sensor (FIS). Description and Operation
    Description The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primar ...

    Emission control system
    The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in ...

    Highway driving
    Tires Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires. Avoid using worn or damaged tires which m ...