Hyundai Sonata: Description and Operation - Electro chromic Inside Rear View Mirror - Body Electrical SystemHyundai Sonata: Description and Operation

Description

The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, Preventing glare from the light. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor detects the strength of the reflecting light and adjusts the reflexibility of the mirror in the range of 7~85%. But, when the reverse gear is engaged, it stops functioning.
1.
The forward facing sensor sees if the brightness of the surroundings is low enough for the mirror to operate its function.
2.
The rearward looking sensor detects glaring of the reflecting light from a vehicle behind.
3.
The ECM is darkened to the level as determined by the rearward looking sensor. When the glaring is no longer detected, the mirror stops functioning.
1. LED indicator
2. ON/OFF Switch
3. Rearward looking sensor
4. Forward looking sensor

    Repair procedures
    Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. ...

    See also:

    Crankshaft Position Sensor (CKPS). Description and Operation
    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the If there is no CKPS signal input, the engine may stop because of ...

    Rear Shock Absorber. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

    General Safety Information and Caution
    Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, ...