Hyundai Sonata: Inhibiter Switch. Description and Operation
Description
|
Item |
Specification |
|
Type |
Combination of output signals from 4 terminals |
|
Power supply |
12V |
|
Range detection |
7-position (P, R, N, D, X, Y, Z) |
|
Failsafe |
1st, 2nd gear is prohibited. |
Transaxle Oil Temperature Sensor. Repair procedures
Removal
1.
Remove the battery and the battery tray. (Refer to
"Charging system" in EE group.)
2.
Remove the under cover (A).
...
Inhibiter Switch. Repair procedures
Removal
1.
Set room side lever and T/M side lever to "N" position.
2.
Remove the battery and the battery tray. (Refer to
&q ...
See also:
Repair procedures
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replac ...
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pich (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
ETC (Electronic Throttle Control) System. Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output v ...
