Hyundai Sonata: Description and Operation
Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through
the AV monitor while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver to always check the inside/ outside rearview mirror and
the area behind the vehicle before and during backing up because there
are blind spots that can't be seen through the camera.
|
Schematic Diagrams
Circuit Diagram
...
Repair procedures
Removal
Back View Camera
1.
Remove the screws, clip and trunk lid trim in the trunk. (Refer
to the BD group - "Trunk Lid")
2.
...
See also:
Water Pipe Components and Components Location
Components
1. Water pipe
...
Stop Signal Electronic Module Schematic Diagrams
System Circuit Diagram
Terminal Function
TeminalDescription1Ground 2HAC/DBC Signal (Active Low)3ESS Signal (Active Low)4Stop lamp5Stop lamp switch6ECU/ SMK7ESS Signal (Active High)8Battery
...
Canister Close Valve (CCV). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the ...