Hyundai Sonata: Repair procedures - Back View Camera System - Body Electrical SystemHyundai Sonata: Repair procedures

Removal

Back View Camera
1.
Remove the screws, clip and trunk lid trim in the trunk. (Refer to the BD group - "Trunk Lid")
2.
Remove the trunk lid garnish.
3.
Remove the back view camera (A) after removing the connector and screws.
Back View Camera Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove glove box housing.
(Refer to BD group - "Crash Pad")
3.
Remove the back view camera unit (A) after removing the nut and connector.

Installation

Back View Camera
1.
Install the back view camera.
2.
Install the trunk lid garnish and trim.
Back View Camera Unit
1.
Install the front back view camera unit.
2.
Install the glove box and housing.
3.
Connect the negative (-) battery terminal.

    Description and Operation
    Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows beh ...

    Hyundai Sonata YF 2011-2014 Owner's Manual
    Owners manual for sixth generation (YF) Hyundai Sonata, model years 2011–2014. The Sonata was available at launch in three specifications, each powered by a new direct-injection 2.4-litre four-c ...

    See also:

    Repair procedures
    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner ...

    Fuel Tank Pressure Sensor (FTPS). Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...

    Temperature control
    Type A Type B The temperature will increase to the maximum by turning the knob to the right. The temperature will decrease to the minimum by turning the knob to the left. When turning the ...