Hyundai Sonata: General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before
starting work.
The support rod must be inserted into the hole near
the edge of the hood whenever you inspect the engine compartment to
prevent the hood from falling and causing possible injury.
Make sure that the support rod has been released
prior to closing the hood. Always check to be sure the hood is firmly
latched before driving the vehicle.
|
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pich (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment
are available starting work.
Special Tools
Use special tools when they are required.
Removal Of Parts
First find th ...
See also:
Windshield Wiper-Washer Switch. Repair procedures
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer S ...
Description and Operation
Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows beh ...
Illuminated engine start/stop button
Whenever the front door is opened, the engine start/stop button will illuminate
for your convenience. The light will go off after about 30 seconds when the door
is closed. ...
