Hyundai Sonata: Hazard Lamp Switch. Repair procedures
Inspection
Hazard Lamp Switch
| 1. |
Remove the center fascia panel.
(Refer to the BD group - "Crash pad")
|
| 2. |
Disconnect the switch from the center fascia panel.
|
| 3. |
Operate the switch and check for continuity between terminals.
|
Removal
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Remove the crash pad garnish.
(Refer to the BD group - "Crash pad")
|
| 3. |
Remove the center fascia panel (B) with hazard lamp switch (A).
|
| 4. |
Disconnect the hazard lamp switch connector (A) and heater control
unit connector (B).
|
Installation
| 1. |
Install the hazard lamp switch.
|
| 2. |
Install the center fascia panel.
|
| 3. |
Install the crash pad garnish.
|
License Lamp. Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the lens (A) after loosening the mounting screws.
...
Rheostat. Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lower crash pad switch (A) from the side crash pad
cover by usin ...
See also:
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM)
or when providing additional keys to the vehicle owner ...
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as ...
Troubleshooting
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of the problem. The numbers
indicate the priority of the like cause of the problem. Check each ...
