Hyundai Sonata: Power Window Relay. Repair procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the junction box.
|
| 3. |
Check for continuity between the terminals.
|
| 4. |
There should be continuity between the No.1 in the I/P-C and No.26(or
39) terminal in the I/P-A when power and ground are connected to the
No.1 terminal in the I/P-C and ground.
|
| 5. |
There should be no continuity between the No.1 terminal in the
I/P-C and No.26(or 39) terminal in the I/P-A when power is disconnected.
[Front]
[Rear]
|
Power Window Switch. Repair procedures
Inspection
Power Window Main Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
...
See also:
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce
the risk of unauthorized vehicle use.
Your immobilizer system is comprised of a small transponder in the ignition key ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it with the
lever in the OFF position. The wipers will operate con ...
Components and Components Location
Components
1. Sub frame
2. Coil spring
3. Upper arm
4. Assist arm
5. Trailing arm
6. Rear axle
...
