Hyundai Sonata: Repair procedures
Inspection
| 1. |
Remove the cowl top cover. (Refer to the wiper)
|
| 2. |
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch ON,
then measure the voltage between the terminals of harness side deicer
connector.
|
Description and Operation
Description
Windshield deicer system prevent windshield wiper from freezing in the
winter season. It consists of deicer in the lower part of windshield, switch
and relay. Body control module ...
Windshield Deicer Switch. Repair procedures
Inspection
1.
The windshield deicer switch inputs can be checked using the GDS.
2.
To check the input value of windshield deicer switch, select ...
See also:
PDM(Power Distribution Module). Components and Components Location
Component
...
Heating and air conditioning
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating
and cooling :
- Heating:
- Cooling: 3. Set the temperature control to the desired position.
...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
