Hyundai Sonata: Specifications
Specifications
|
Item |
Specification |
|
|
Clutch operation method |
Hydraulic type |
|
|
Clutch cover assembly |
Type |
Diaphragm spring strap |
|
Clutch disc |
Type |
Single dry with diaphragm |
|
Facing diameter (outside x inside) |
Ø240 × Ø155mm (Ø9.4488 × Ø6.1024in.) |
|
|
Concentric slave cylinder |
Cylinder diameter (inside x outside) |
Ø32.2 x Ø44mm (Ø1.2677 × Ø1.7323in.) |
Service Standard
|
Item |
Specification |
|
Clutch disc thickness [When free] |
8.7 (-0.3~+0.25mm) [0.3425 (-0.0118~+0.098in.)] |
|
Clutch pedal height |
216 mm (8.5039 in.) |
|
Clutch pedal free play |
6 ~ 13 mm (0.2362 ~ 0.5118 in.) |
|
Clutch pedal stroke |
145 ± 3mm (5.7087 ± 0.1181 in.) |
|
Clutch disc rivet depth |
1.3 mm Min. (0.0512 in. Min.) |
|
Diaphragm spring end height difference |
0.5 mm (0.0197 in.) |
|
Clutch master cylinder clearance to piston |
1.6 mm (0.0630 in.) |
Tightening Torques
|
Item |
N.m |
kgf.m |
lb-ft |
|
Clutch cover asssembly |
24.5~34.3 |
2.5~3.6 |
18.1~26.0 |
|
Ignition lock switch |
7.8~9.8 |
0.8~1.0 |
5.8~7.2 |
|
Clutch pedal and pedal mounting bolt |
9.8~14.7 |
1.0~1.5 |
7.2~10.8 |
Lubricants
|
Item |
Specified lubricants |
Quantity |
|
Input spline |
CASMOLY L9508 |
0.2g |
|
Concentric slave cylinder assembly |
KLUBER 9R100 |
As required |
|
Clutch pedal shaft and bushings |
Chassis grease SAE J310, NGLI NO.1 |
Special Service Tools
Special Service Tools
Tools
(Number and Name)
Illustration
Use
09411-1P000
Clutch disc guide
Installation of the ...
See also:
Rear Assist Arm. Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Rear view camera
WARNING
This system is a supplementary function only. It is the responsibility of
the driver to always check the inside/outside rearview mirror and the area behind
the vehicle before ...
Alternator Schematic Diagrams
Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target voltage data
to the alternator via a PWM signal.(High voltage: 4V or h ...