Hyundai Sonata: Trailing Arm. Repair procedures - Rear Suspension System - Suspension SystemHyundai Sonata: Trailing Arm. Repair procedures

Replacement

1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Be careful not to damage to the hub bolts when removing the rear wheel & tire.
2.
Disconnect the parking brake cable (A) with the rear brake assembly.
3.
Loosen the parking brake cable bracket nuts (A) & trailing arm mounting nuts (B) and then remove the trailing arm with the rear axle.
Tightening torque:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

4.
Loosen the parking brake cable bracket bolt (A).
5.
Loosen the mounting bolt and then remove the trailing arm (A) with the frame.
Tightening torque:
98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

6.
Installation is the reverse of removal.

    Rear Assist Arm. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

    Rear Cross Member. Repair procedures
    Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

    See also:

    To resume cruising speed at more than approximately 25 mph (40 km/h)
    If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch ...

    Relay Box (Engine Compartment). Schematic Diagrams
    Circuit Diagram ...

    Identification Number Locations
      ...