Hyundai Sonata: Valve Body. Repair procedures - Valve Body System - Automatic Transaxle SystemHyundai Sonata: Valve Body. Repair procedures

Removal

1.
Remove the battery and the battery tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
3.
Replace new gasket and the plug after drining the automatic transaxle fluid by removing the drain plug.
(Refer to "Automatic transaxle system" in this group.)
4.
Remove the valve body cover (A) and eyebolt (B).
Tightening torque:
(A) 12.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
(B) 34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.6 lb-ft)
The gasket of the eyebolt use new one.
Remove installation bolts in the engin room first and then remove others under the vehicle.

5.
Remove the plate and the detend spring (A) after removing the bolt.
Tightening torque:
24.5 ~ 35.3 N.m (2.5 ~ 3.6 kgf.m, 18.1 ~ 26.0 lb-ft)

6.
Remove the bolt (3ea) after disconnecting the solenoid valve (B) connector and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

7.
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Installation

1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
Continue to apply liquid gasket at application points at the valve body cover with Ø2.5mm (0.0984in.) thickness.
Liquid gasket Part name :
Threebond 1281B or LOCTITE FMD-546
•
Adding automatic transaxle fluid. (Refer to "automatic transaxle system" in this group.)

    Valve Body. Specifications
    Specification Piece 3pcs Spool 20ea Control Full line pressure variable control Torque converter release control ...

    Solenoid valve. Specifications
    Specification Item Function Piece Specification VFS 　 　 26/B T/Con 2 Control p ...

    See also:

    Heated Oxygen Sensor (HO2S). Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between th ...

    Components and Components Location
    Components 1. Piston ring 2. Piston 3. Connecting rod 4. Connecting rod upper bearing 5. Piston pin 6. Connecting rod lower bearing 7. Connecting rod bea ...

    Brake Pedal. Repair procedures
    Removal 1. Remove the crash pad lower panel. (Refer to the Body group- crash pad). 2. Pull down steering column shaft after removing bolts ...