Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Rail Pressure Sensor (RPS). Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Accelerator Position Sensor (APS). Specifications

Specification Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 ...

See also:

Brake Pedal. Repair procedures
Removal 1. Remove the crash pad lower panel. (Refer to the Body group- crash pad). 2. Pull down steering column shaft after removing bolts ...

Economical operation
Your vehicle's fuel economy depends mainly on your style of driving, where you drive and when you drive. Each of these factors affects how many miles (kilometers) you can get from a gallon (l ...

Instrument Cluster. Repair procedures
Inspection Speedometer 1. Adjust the pressure of the tires to the specified level. 2. Drive the vehicle onto a speedometer tester. Use whee ...