Hyundai Sonata: Filler-Neck Assembly. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Sonata: Filler-Neck Assembly. Repair procedures

Removal

1.
Disconnect the fuel filler hose (A), the vapor tube quick-connector (B), and the ventilation tube quick-connector (C).
2.
Remove the rear-LH wheel, tire, and the inner wheel house.
3.
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).
4.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting bolts (A).


Installation

1.
Installation is reverse of removal.
Filler-neck assembly bracket installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

    Fuel Filter. Repair procedures
    Replacement 1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel ...

    Accelerator Pedal. Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor conn ...

    See also:

    Manifold Absolute Pressure Sensor (MAPS). Schematic Diagrams
    Circuit Diagram ...

    Relay Box (Passenger Compartment). Components and Components Location
    Components ...

    Brake fluid
    Checking the brake/clutch fluid level Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the ...