Hyundai Sonata: Accelerator Pedal. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Sonata: Accelerator Pedal. Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and bolt (C), and then remove the accelerator pedal module.


Installation

1.
Installation is reverse of removal.
Accelerator pedal module installation nut:
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Filler-Neck Assembly. Repair procedures
    Removal 1. Disconnect the fuel filler hose (A), the vapor tube quick-connector (B), and the ventilation tube quick-connector (C). 2. ...

    Delivery Pipe. Repair procedures
    Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be in ...

    See also:

    Fuel Tank Air Filter. Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the canister close valve connector (A ...

    Repair procedures
    General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

    Manual climate control system
    Type A Type B 1. Front windshield defrost button 2. Rear window defroster button 3. Fan speed control knob 4. Mode indicator 5. Mode selection button 6. Air intake control button 7. Air co ...